资料下载
×
用标准连续矢量格式文件对XC9500器件在系统编程,并用自动
消耗积分:5 |
格式:rar |
大小:333 |
2009-05-15
分享资料个
XC9500 devices use a standard 4-wire Test Access Port
(TAP) for both In-System Programming (ISP) and IEEE
1149.1 boundary scan (JTAG) testing. Therefore, manufacturers
can reduce their overall system cost and reduce
device damage due to unnecessary handling by using
automatic test equipment (ATE) or boundary-scan based
tools development to both program and test these devices.
The XC9500 Boundary-scan architecture is shown in
Figure 1.
(TAP) for both In-System Programming (ISP) and IEEE
1149.1 boundary scan (JTAG) testing. Therefore, manufacturers
can reduce their overall system cost and reduce
device damage due to unnecessary handling by using
automatic test equipment (ATE) or boundary-scan based
tools development to both program and test these devices.
The XC9500 Boundary-scan architecture is shown in
Figure 1.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
评论(0)
发评论
- 相关下载
- 相关文章
