资料下载
×
Measurement and Control of RF
消耗积分:3 |
格式:rar |
大小:433 |
2009-09-23
分享资料个
Measurement and Control of RF Power (Part III):Response of Log amp to Different Signal Types
Log amps are generally specified for a sine wave input. Like diode detectors, log amps
are not true rms responding. Differing signal waveforms in a log amp shift the effective
value of the log amp’s intercept upwards or downwards. Graphically, this looks like a
vertical shift in the log amp’s transfer function (see Fig. 19.), the logarithmic slope being
unaffected. The figure shows the transfer function of the AD8307 when alternately fed by
an un-modulated sine wave and by a forward-link CDMA channel of the same rms power
(9 channels active.) The output voltage differs by the equivalent of 3.55dB (88.7 mV)
over the complete dynamic range of the device.
Log amps are generally specified for a sine wave input. Like diode detectors, log amps
are not true rms responding. Differing signal waveforms in a log amp shift the effective
value of the log amp’s intercept upwards or downwards. Graphically, this looks like a
vertical shift in the log amp’s transfer function (see Fig. 19.), the logarithmic slope being
unaffected. The figure shows the transfer function of the AD8307 when alternately fed by
an un-modulated sine wave and by a forward-link CDMA channel of the same rms power
(9 channels active.) The output voltage differs by the equivalent of 3.55dB (88.7 mV)
over the complete dynamic range of the device.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
评论(0)
发评论
- 相关下载
- 相关文章
