资料下载
×
使用X84041 串行EEPROM直接与并行数据总线接口的特
消耗积分:3 |
格式:rar |
大小:66 |
2009-05-23
分享资料个
In order to complete the interface, there are two additional unique sequences to reset the device and to initiate a nonvolatile write cycle. A RESET condition is recognized by the X84041 whenever the system processor issues the following sequence:"read", "write a zero", and "read". This 3-bus cycle
sequence is used to initialize the part before a read or write sequence or to interrupt a sequence already in progress. An INITIATE NONVOLATILE WRITE
CYCLE condition is recognized by the X84041 whenever the system processor issues the following sequence: "read", "write a one", and "read". This
sequence is used to begin an internal write cycle after data has been loaded into the device. An additional feature of the device is the ability to determine the early completion of an internal nonvolatile write cycle.
This can be accomplished by "polling" the level of the I/O pin during a nonvolatile write cycle. When the I/O pin can be read as a logic HIGH, then the cycle is complete and the part is again able to interact within
the system.
sequence is used to initialize the part before a read or write sequence or to interrupt a sequence already in progress. An INITIATE NONVOLATILE WRITE
CYCLE condition is recognized by the X84041 whenever the system processor issues the following sequence: "read", "write a one", and "read". This
sequence is used to begin an internal write cycle after data has been loaded into the device. An additional feature of the device is the ability to determine the early completion of an internal nonvolatile write cycle.
This can be accomplished by "polling" the level of the I/O pin during a nonvolatile write cycle. When the I/O pin can be read as a logic HIGH, then the cycle is complete and the part is again able to interact within
the system.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
评论(0)
发评论
- 相关下载
- 相关文章
