×

客车照明与信号灯多路传输控制系统的设计

消耗积分:3 | 格式:rar | 大小:135 | 2009-06-01

duke刘

分享资料个

本文以客车照明与信号灯的位置分布和安全性要求作为节点划分依据,采用控制器局
域网CAN(Controller Area Network)构建了客车照明与信号灯多路传输控制系统,设计了系统结构、节点、相关流程图与硬件结构图,并采取指令控制——状态检测——状态指示的控制方式,实现车灯状态自动检测,增强客车行驶安全性。
关键词:客车;多路传输;CAN;检测

项目资助:教育部高等学校博士点专项科研项目基金资助项目(20020497009)
Design of Passenger Car Illumination and Signal Lamp Multiplexing Control System
HU Jian, LI Gangyan, WU Xiude, ZHOU Jianhua (School of Mechanical & Electronic Engineering, Wuhan University of Technology, Wuhan, China 430070.) Abstract: The author constructs passenger car illumination and signal lamp multiplexing control system based on CAN (Controller Area Network) and designs system structure, node parameters, correlative flow chart and hardware framework. The design of system node is according to the position and security of passenger car illumination and signal lamp. This paper uses the control
method of command control----status testing----status indication to realize passenger car lamp status automotive test and enhance passenger car‘s security.
Key Words: Passenger Car; Multicomplexing Transmission; CAN; Test
0 引

下载资料需要登录,并消耗一定积分。

声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉

评论(0)
发评论

下载排行榜

全部0条评论

快来发表一下你的评论吧 !