资料下载
×
基于J1939的汽车CAN总线教学实验系统
消耗积分:5 |
格式:rar |
大小:185 |
2009-08-06
丁冬芹
分享资料个
针对J1939协议培训要求，构建了一个基于J1939协议的汽车总线培训实验系统。系统硬件由计算机、Kvaser CAN总线分析仪以及基于J1939协议的汽车CAN总线模块包括仪表板模块、车身电器模块、发动机ECU模块等组成。系统界面由WarwickX-Analyser设计，测试结果直观地显示在显示器上。系统实时监控汽车J939数据并能完整记录、显示波形和打印。
关键词： J1939 协议汽车 CAN 总线实验系统
Abstract： An Experimental System of Vehicle can bus for training and teaching purpose based on J1939 protocol was established. The system hardware was composed of notebook, Kvaser CAN bus analyzer and CAN bus modules including meter board module, vehicle body modules, engine ECU module and so forth. And the system operating interface was using X-analyser，an CAN analyzing and simulating software, with high layer protocol test results displayed on screen. This system can measure dynamic J1939 signals and output graph accordingly.
Key words：J1939 protocol, vehicle CAN bus, experiment system
关键词： J1939 协议汽车 CAN 总线实验系统
Abstract： An Experimental System of Vehicle can bus for training and teaching purpose based on J1939 protocol was established. The system hardware was composed of notebook, Kvaser CAN bus analyzer and CAN bus modules including meter board module, vehicle body modules, engine ECU module and so forth. And the system operating interface was using X-analyser，an CAN analyzing and simulating software, with high layer protocol test results displayed on screen. This system can measure dynamic J1939 signals and output graph accordingly.
Key words：J1939 protocol, vehicle CAN bus, experiment system
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
评论(0)
发评论
- 相关下载
- 相关文章
