资料下载
×
IEEE Std 383™-2003/1983标
消耗积分:5 |
格式:rar |
大小:444 |
2008-07-27
kmno4
分享资料个
Std 383™-2003
(Revision of
IEEE Std 383-1974)
IEEE Standard for Qualifying Class 1E
Electric Cables and Field Splices for
Nuclear Power Generating Stations
Sponsor
Nuclear Power Engineering Committee
of the
IEEE Power Engineering Society
Approved 12 December 2003
IEEE-SA Standards Board
Abstract: This standard provides general requirements, direction, and methods for qualifying
Class 1E electric cables, field splices, factory splices, and factory rework for service in nuclear power
generating stations. Categories of cables covered are those used for power, control, and
instrumentation services, including signal and communication cables. Field cables, wires, and splices
are within the scope of this standard. Cables, wires, and splices within or integral to other devices
(e.g., instruments, panels, motors, etc.) should be qualified using the requirements in the applicable
device standard or IEEE Std 323TM-1983, as appropriate. However, this standard's requirements
may be applied to the wire and cable within these devices.
Keywords: class 1E electric cables, factory rework, factory splices, field splices, qualified life, representative
cable, representative splices
(Revision of
IEEE Std 383-1974)
IEEE Standard for Qualifying Class 1E
Electric Cables and Field Splices for
Nuclear Power Generating Stations
Sponsor
Nuclear Power Engineering Committee
of the
IEEE Power Engineering Society
Approved 12 December 2003
IEEE-SA Standards Board
Abstract: This standard provides general requirements, direction, and methods for qualifying
Class 1E electric cables, field splices, factory splices, and factory rework for service in nuclear power
generating stations. Categories of cables covered are those used for power, control, and
instrumentation services, including signal and communication cables. Field cables, wires, and splices
are within the scope of this standard. Cables, wires, and splices within or integral to other devices
(e.g., instruments, panels, motors, etc.) should be qualified using the requirements in the applicable
device standard or IEEE Std 323TM-1983, as appropriate. However, this standard's requirements
may be applied to the wire and cable within these devices.
Keywords: class 1E electric cables, factory rework, factory splices, field splices, qualified life, representative
cable, representative splices
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
评论(0)
发评论
- 相关下载
- 相关文章
