×

AD-FMCAD3-EB3快速启动指南

消耗积分:2 | 格式:pdf | 大小:201.76KB | 2021-05-26

孙成红

分享资料个

This version (28 Aug 2015 13:11) was approved by Dragos Bogdan.The Previously approved version (28 Aug 2015 08:37) is available.Diff

Table of Contents

AD-FMCADC3-EBZ Quick Start Guides

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD-FMCADC3-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

Supported Carriers

The AD-FMCADC3-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board AD-FMCADC3-EBZ
VC707 v
ZC706 v

The supported OS are:

Board HDL Linux Software No-OS Software
VC707 v v -
ZC706 v v -

Hardware Setup

In most carriers, the AD-FMCADC3-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A typical setup is shown below.

下载并关注上传者 低至0.43元/天 开通VIP 免费下载

声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉

评论(0)
发评论

下载排行榜

全部0条评论

快来发表一下你的评论吧 !